Deutsch
-
×
4-colour thermal transfer printing for card transponders HF-KT 50
1 × € 6,60Incl. tax -
×
HF Key Transponder HF-ST 10 (Mifare) blue
1 × € 15,00Incl. tax -
×
Replacement locking bolt 8360B for locking element 8360
1 × € 22,08Incl. tax -
×
histar 1015-B1 Infrared Motion Detector
1 × € 145,20Incl. tax -
×
Distributor empty enclosure aP VT 80/60 DA
1 × € 96,00Incl. tax -
×
comstar pro B25 Infrared Motion Detector
1 × € 111,60Incl. tax -
×
Mechanical blind core TU 6712-BK
1 × € 57,60Incl. tax -
×
Design frame DR 800 aP DB-703 mica iron
1 × € 48,60Incl. tax -
×
histar 1015AM-B1 Infrared Motion Sensor
1 × € 210,00Incl. tax -
×
Universal Mounting Bracket 8325.W
1 × € 51,24Incl. tax
DR M 2P 255 Surge Arrester
Part Number: 100057150 DR M 2P 255 surge arrester,
consisting of a base part and a trap
module, as fine protection for the 230 V
mains connection of hazard alarm systems.
The
Out of stock
DR M 2P 255 Surge
Deflector
Surge arrester DR M 2P 255,
consisting of base part and arrester
module, as fine protection for the 230 V
mains connection of hazard alarm systems.
The surge arrester is mounted on
a grounded 35 mm DIN rail
.
Show only reviews in English (0)
Be the first to review “DR M 2P 255 Surge Arrester”
Related products
Out of stock
Surge arresters
Part Number: 100057151 arrester module BXT ML2 BE S 5 for the protection of one comlock interface each at TELENOT hazard alarm panels. The arrester module is replaced by one
Alarm systems
Part Number: 100057166 Two SAK BXT LR spring terminals for the protected and unprotected side of arrester modules for permanent, low-impedance shield contacting
Alarm systems
Part Number: 100057163 basic part BXT BAS 4 as a 4-pin universal connection terminal for accommodating a arrester module. When the arrester module is removed, the signal line
Surge arresters
Part Number: 100057154 arrester module BXT ML4 BE 24 for the protection of two 24 V limit lines or 24 V outputs (e.g. siren, flash lamp, operating voltage, operator
Surge arresters
Part Number: 100057158 mounting set DIN rail MSH1 for the installation of surge arresters in a distributor empty housing, housing type GR100. The set consists of 2 DIN rails (
Alarm systems
Part Number: 100057156 arrester module BXT ML4 BD HF 5 for protection of a system bus (com2BUS A and B) of TELENOT hazard alarm panels or of a TLON network of the TE
Alarm systems
Part Number: 100057157 basic part BXT BAS as a 4-pole universal feed-through terminal to accommodate a arrester module without signal interruption. The arrester module is set to a
Surge arresters
Part Number: 100057159 arrester module BXT ML4 BD HF 24 for the protection of one ISDN connection (So) of TELENOT transmission equipment or one VDSL connection. That
Reviews
There are no reviews yet.