Input Output Module MIO21-C2B/B1 mini

Input Output Module MIO21-C2B/B1 mini

In-output modules enable conventional detectors to be connected via the BUS-1 to the complex intrusion detector control panel. Input/output modules can be connected to the hiplex intrusion alarm panel via BUS-1 or com2BUS. The number of connectable input/output modules depends on the intrusion detector panel and the interface used (BUS-1/com2BUS). The input output modules are integrated into the new housing design. To ensure operational safety, the input output modules have a shielding wire strip for fast and continuous shielding. In addition, the input/output modules are equipped with a wall breakaway device. The devices for flush-mounted mounting are also VdS- approved thanks to additional TELENOT extra-low voltage appliance sockets. The connection technology with spring-loaded terminals also reduces the installation effort. The com2BUS / BUS-1 interfaces can be used to save wires with a cable length of up to 1000 m. This results in enormous economic advantages during installation. In the case of VdS systems, it should be noted that all BUS-1 components per BUS-1 and all com2BUS components per com2BUS may only be assigned to one fuse area. In-output module with 2 inputs and 1 output for connecting conventional detectors to the BUS-1 or com2BUS interface. Due to the low installation effort, a time- and cost-effective installation is possible. The inputs are resettable and therefore suitable for connecting glass break detectors (GBS). Due to the low current consumption of max. 5 mA, the input output module is also very energy-efficient. The output is GND-switching and can be freely parameterized. The input/output module is intended as a circuit board with a potting compound on the back for insertion into different housings (e.g. cavity wall boxes). It therefore has no separate housing and no mounting holes.